DISCONTINUED Create RC5A-3 - Heavy duty rotator with variable presets

CREATE RC5A-3 Heavy Duty Rotator with controller ( with presets)

This is a heavy duty rotator for larger antennas which uses worm gears for higher torque

The most important criteria in the selection of a rotator are retarding torque and rotating torque. Because different antenna have different weights and slenderness ratios, the rotator's characteristics vary to a large extent.

Even among antennas of the same weight, large braking torque is required for an antenna of long boom length. The specifications we show were calculated based on a wind velocity of about 30m/s.These performances are applicable to one antenna only.

If the rotator is used at reduced speed, the tolerance for braking torque increases by 20 to 30%

Requires 7 core cable (0.75 mm (2) up to 50m length and 1.25mm (2) up to 80m length

Specifcation

• Total Azimuth rotation 370°
• Controller Voltage 110/230VAC 150VA,
• Maximum vertical load 700 kg
• Horizontal load 1000 kg,
• Rotating torque 16 kg/metre
• Brake torque 200 kg/metre
• Motor, variable speed 75-110 sec
• Reversing delay 3 sec
• Mast diameter 48-63 mm,
• Preset control
• Weight 7kg rotator and 2kg controler